Airthings Wave Radon Detector

Since I’m all about adding wireless sensors and believe keeping an eye on the humidity and temperature readings within my home important I thought I would keep adding by including a radon sensor. Needless to say, I had placed a pre-order back in January and arrived at my door on April 29th.

In my testing I was a little concerned when the radon graph spiked to about 9.1  pCi/L however I remember when I had my home tested for radon when I originally purchased it, the test needed to run for at least a day or two for an accurate reading. I emailed support to confirm and below was their response.

Hi,
That’s normal. Radon fluctuate a lot over time. Just let the monitor record data, and then look at the long term average. That’s the important number.

Thanks

Fred

Airthings
Customer Support
Brent Broge
May 4, 21:39 CEST

Hi, I setup my Airthings wave on Saturday night and noticed that it peaked to 9.1 pCi/L Tuesday morning. It has since been dropping but is that peak anything to be concerned with? The average is currently sitting around 3.4 pCi/L.

Thank you!

This device will currently only sync to my phone via Bluetooth so unfortunately I have to use two different apps. The app is decent and provides what you need. The graph could be a little better, for example, it would be nice to zoom in and out. I’d like to eventually include this data into Comfort Click.